Technical Pro AX3000 - 页 5

POWER
Wiring the Amplifier using Speaker Wire
There are two banana binding post outputs on the rear of AX3000. To use the banana binding post
Outputs you will need to use a banana connector or speaker wire. You can connect the speakers
To these speaker ouputs via the speaker cable included. See below on how to connect two speakers
To the AX3000 main speaker outputs using speaker wire.
------------------------------------------------------------------------------------------------------------------------------
1. Remove approximately 10mm(0.4 in) of insulation from the end of each speaker
Cable and twist the exposed wires of the cable together to prevent short circuits.
-----------------------------------------------------------------------------------------------------------------------------------------------
2. Unscrew the banana binding post output terminal on the rear of the AX3000. Insert the exposed
Speaker wire into the opening.
-----------------------------------------------------------------------------------------------------------------------------------------------
2. Tighten the knob.
NOTE: WHEN MAKING THESE CONNECTIONS THE POWER OF THE AX3000 AND THE SIGNAL
SOUCE SHOULD ALL BE IN THE OFF POSITION WITH THE VOLUME LEVELS TURNED DOWN.