16 TouchScreen TCA 400 Getting Started Guide – Installation
4
5
6
7
Connect the stand to the back plate
of Touchscreen by sliding in both
ends.
Place down the back plate then slide
up to snap the back plate in. Tuck the
AC power cable into the channel at
the bottom of the back plate.
Position Touchscreen near an un-
switched wall outlet (not controlled
by a light switch).
Unwrap the 4 volt battery from its
packaging and insert the end with
the +/– contacts rst. Snap the
opposite end down in the battery
compartment to complete battery
installation.
The rechargeable battery that came with your Touchscreen is only available WARNING:
through your service operator. If your battery needs to be replaced, contact your service operator
to arrange for replacement.
To Next Page
Loading...
Need help?
General