Operation
20
A maximum of two Bluetooth
®
devices can be connected at the same time.
The default setting is “OFF”.
• When the “Technics Audio Connect” app is used, you can set to “ON”.
For information about the connection and registration of Bluetooth
®
devices and the unit (l 13,
“Connecting a Bluetooth
®
device”)
1 Pair this unit with each of the Bluetooth
®
devices.
2 Connect the first Bluetooth
®
device and the unit.
3 Connect the second Bluetooth
®
device and the unit.
Note
• For more details, including more specific setup instructions, refer to the operating instructions for the Bluetooth
®
devices.
• This may not work with some apps and software.
• LDAC cannot be played back when this function is ON.
• When the unit is turned off, an English guidance message will be heard indicating the battery level.
• When the battery level starts to run low, the blinking LED indicator will turn from blue to red, and as it drops further,
you will be notified by one beep every 1 minute.* When the battery runs out, a tone and a guidance message will be
heard and the power will turn off.
* If you press [Í/I] twice quickly, an English guidance message will be heard and you can check the battery level.
Creating multi-point connections
Battery level notification
To Next Page
Loading...
Need help?
General
