Technics EAH-AZ60 - Connecting a Paired Bluetooth Device

Preparation
20
1
Take the earphones out of the charging cradle.
• The earphone LEDs light (blue) and the earphones turn on about 4 seconds later.
A beep will sound, and the earphone LEDs (blue)* will blink slowly.
* The batteries are low when they are blinking in red.
2
Do Steps 2 to 3 of “Connecting by pairing (registering) your earphones with a
Bluetooth
®
device” (l 19).
3
Confirm that the earphones and the Bluetooth
®
device are connected.
Note
• This unit remembers the device lastly connected. Connection may be automatically established after step 1 (see
above).
• The unit can connect to a maximum of two Bluetooth
®
devices at the same time. (l 25, “Creating multi-point
connections”)
Connecting a paired Bluetooth
®
device
eah_az60_az40_pnqp1675za_full_eng_s.book 20 ページ ２０２１年９月２８日 火曜日 午前１０時７分