Technics EAH-AZ60

Operation
23
Using the external sound control
The external sound control function switches between Noise cancelling and Ambient sound.
1 While wearing the earphones, touch and hold the touch sensor (R) for about 2 seconds.
• The mode is switched each time you touch and hold the touch sensor. (A guidance message will notify you of the
mode you switched to.)
[EAH-AZ60]
• The default level setting is “Noise cancelling”.
• When the “Technics Audio Connect” app is used, you can set to “OFF”.
[EAH-AZ40]
• The default level setting is “Ambient sound OFF”.
2 Adjust the volume of the playback device.
∫ Noise cancelling ([EAH-AZ60] only)
Reduces the sounds (noise) you can hear from outside.
• Noise cancelling can be optimised with the “Technics Audio Connect” app. Adjust it beforehand to achieve the best
condition.
• While using the noise cancelling function, a very small amount of noise which is generated from the circuit that
reduces noise may be heard, but this is normal and not indicative of any trouble. (This very-low-level noise may be
heard in quiet places or in the blank parts between tracks.)
∫ Ambient sound
You can hear ambient sound through the microphones embedded in the earphones while enjoying music.
Noise cancelling Ambient sound
Ambient sound
Ambient sound
OFF
eah_az60_az40_pnqp1675za_full_eng_s.book 23 ページ ２０２１年９月２８日 火曜日 午前１０時７分