Other
16
Restoring to the factory settings
You can restore the unit to the factory settings (original settings upon purchase). Performing the following
procedure returns the volume level, etc., to the factory settings and deletes the information for all registered
devices. Charge the battery before restoring the unit.
1 While the power is turned off, press and hold [Í/I ( )] for at least 5 seconds until the
power/pairing LED lights alternately in blue and red.
2 While the power/pairing LED is lighting alternately in blue and red, slide and hold the
Multiple functions button towards “+” and at the same time press and hold [Í/I ( )] for
at least 5 seconds.
• The default settings will be restored after the power/pairing LED (blue) blinks fast and the unit turns off.
∫ Attention
• When pairing a device again, delete the registering information (Device: “EAH-F50B”) from the Bluetooth
®
device’s
menu, and register this unit with the Bluetooth
®
device again. (l 8)
Copyright, etc.
The Bluetooth
®
word mark and logos are registered trademarks owned by Bluetooth SIG, Inc. and any use of
such marks by Panasonic Corporation is under license.
Other trademarks and trade names are those of their respective owners.
Siri is a trademark of Apple Inc.
Android is a trademark of Google LLC.
LDAC and LDAC logo are trademarks of Sony Corporation.
Qualcomm aptX is a product of Qualcomm Technologies, Inc. and/or its subsidiaries.
Qualcomm is a trademark of Qualcomm Incorporated, registered in the United States and other countries.
aptX is a trademark of Qualcomm Technologies International, Ltd., registered in the United States and other
countries.
Other system names and product names appearing in this document are in general the registered
trademarks or trademarks of the respective developer companies.
Note that the
TM
mark and
®
mark do not appear in this document.
Remove the right ear pad to view certification information. (1)
Certification information (A) is indicated on the speaker plate portion (B), which becomes visible when the
right ear pad (R side) is removed. (2)
To attach the ear pad, fit the part D of the ear pad into the part C. (3)
Do not pull the ear pad with force when attaching or removing.
To Next Page
Loading...
Need help?
General
