Technics QUARTZ SL-7 - Removing Packing Material

Removing packing material
1. Turn the unit upside down and completely unscrew locking
screws Al, A2, and AS. (Fig. 1.)
2.
Unscrew
spacers
B1,
B2,
and
B3
(turn
counterclockwise).
Then
remove
spacers
and
washers,
along
with
the
screws.
(Fig.
2.)
3. Turn the unit right side up and press the cabinet lock
button on the upper cabinet to open it.
4. Pull off the tonearm protection spacer. Be careful not to
touch the stylus. (Fig. 3.)
Notes:
1.
When
you
turn
the
unit
upside
down,
put
it
on
a
rug
or
soft
cloth
to
avoid
marring
the
cabinet
top.
2.
Keep
all
packing
material
and
spacers,
screws
and
washers
in
case
you
need
to
ship
the
unit
at
some
future
date.
3. To repack, proceed in the reverse order of that described
above (4~1).
However, be sure that the tonearm is all the way to the
start position (at the outer edge of the platter).
Note that the tonearm will not return to the start position
if you press the power switch during play.
Do not lock the tonearm when replacing the tonearm protec-
tion spacer.
4. There are three turntable locking screw holes; they are most
easily aligned when the platter is turned so the light guide
slits C, D are lined up as shown in the diagram. Note that
there is a screw hole under only one of the slits. Turn the
platter 180° to confirm this. (Fig. 4.)
Connections
@connect the output terminals (Fig. 5.)
Output terminals Amplifier or Receiver
L (White) ————————_» JI Channel
R (Red) ————_» EEE Channei
GND (Spade lug) —_—» [eXp}
Note:
Always connect the ground cord to the GND terminal on
your amp or receiver to prevent hum.
@connect the AC power plug (Fig. 5.)
Connect the AC power plug to an AC wall socket.
Caution: ;
Do not plug this unit into high voltage outlets intended for
heavy duty appliances as this will cause a fire hazard and
damage the unit.
© DC input jack (for DC power supply) (Fig. 5.)
(O-@@):
This unit can be powered by either an AC or DC source.
(Use only Panasonic car adaptor RP-952.)
Caution:
This unit takes a DC 12V power supply. Therefore, check the
voltage and polarity of the adaptor you use. If the power
supply drops below 10V, the SL-7 will not operate properly
So be sure the battery is completely charged, The adaptor
current capacity should be rated at 800mA or higher,
When using DC power from a car battery (via the cigarette
lighter) or other source, plug the DC adaptor into this jack.
When you have the car battery adaptor plugged into the car’s
cigarette lighter, the adaptor's fuse may blow if you allow the
adaptor’s DC-in plug to touch a metal part of the car.
Therefore, always unplug the adaptor from the cigarette
lighter when not using it.
The adaptor’s fuse may also blow if you allow the SL-7
‘cabinet to contact a metal part of the car, so be careful.