Need help?Do you have a question about the Technics SL-7 and is the answer not in the manual?
Procedures for setting auto start and auto return positions.
Method for adjusting the stylus pressure.
Adjustments for tonearm offset and servo gain.
Procedure for adjusting the tonearm lift height.
Procedure for adjusting the tonearm offset angle.
Detailed procedure for adjusting the tonearm lift height.
General| Drive Method | Direct drive |
|---|---|
| Turntable Platter | Aluminum die-cast |
| Platter Diameter | 300 mm |
| Speeds | 33 1/3, 45 rpm |
| Wow and Flutter | 0.025% WRMS |
| Rumble | -78 dB (DIN-B) |
| Tonearm Type | Linear tracking |
| Effective Length | 105 mm |
| Dimensions | 315 x 88 x 315 mm |
| Motor | DC motor |
| Output Voltage | 2.5 mV |
| Power Supply | AC 120V, 60Hz |
To Next Page
