\
(®, ®).
oooooooooooooooooooo.,ooo°,ooo.oo.,.oo,,.ooo,..ooooooooooo,oooooo..,o0
Insert the batteries in the
correct polarities ((_, O).
o.o.oooooo,ooooooooooo,,oo.o,ooo.o,o,oooo,..ooooooooooo,ooooo,oo=o**ooooooo
r_ Remote control signal sensor
D ....
Transmission
window
Avoid any obstacles
ooo1-11
About 7 meters (23 feet) in
front of the signal sensor.
(1"heactual range will
depend on the angle at
which the remote control is
used.)
[]
• Thoroughly clean the battery compartment before inserting new
batteries.
• Do not mix old and new batteries, or batteries of different types
(carbon and alkaline, etc.).
• If you will not use the remote control for a long period of time,
remove the batteries and store them in a cool, dark place.
• Do not use rechargeable type batteries.
• Do not attempt to recharge alkaline or carbon batteries.
• Always remove old, weak or worn-out batteries promptly and dis-
pose of them properly.
• Never subject batteries to excessive heat or flame; do not attempt
to disassemble them; and be sure theY are not short-circuited.
• If the leaking electrolyte comes into c_)nt_'__ttfi "sl_in0r clothes,
flush with water immediately.
When you need to replace these batteries
Usetwo R6/LR6,AA, UM-3 batteries.
[]
Be sure the transmission window and the signal sensor are free
from dust. Excessive dust might effect performance.
The operation may not be correct if direct sunlight or other strong
light source strikes the signal sensor of this unit. If there is a prob-
lem, place the unit away from the light source.
==
t
To Next Page
Loading...
Need help?
General
