55
Using PHONO cable/
analog audio cable
1 Disconnect the AC power supply cord.
2 Connect this unit and a device.
3 Connect the AC power supply cord to
this unit. (⇒ 25)
• Turn the volume down before switching the
input source.
4 Press [>SELECT<] repeatedly to select
“LINE”/ “PHONO”.
5 Start playback on the connected device.
Note
• When connecting a turntable with a built-in
PHONO equalizer, turn the equalizer of turntable
off or connect the PHONO cable to the analog
audio input terminals (LINE) of this unit.
• When connecting a turntable with a PHONO
earth lead, connect the PHONO earth lead to the
PHONO EARTH terminal of this unit.
Switching a phase of record to
play
Sets to play back and enjoy the inverted phase
audio.
• The factory default is “Normal”.
1 Press [MENU].
2 Press [
], [ ] repeatedly to select
“Phase” and then press [OK].
3 Press [
], [ ] to select “Normal” /
“Invert” and then press [OK].
• While setting to “Invert”, “INV” is displayed.
To Next Page
Loading...
