Technics SA-DA15 - Changing Remote Control Codes

6 Disassembly and Main Component
Replacement Procedures
TOP PREVIOUS NEXT
“ATTENTION SERVICER”
Some chassis components maybe have sharp edges. Be careful when diassembling and servicing.
1. This section describes procedures for checking the operation of the major printed circuit
boards and replacing the main components.
2. For reassembly after operation checks or replacement, reverse the respective
procedures./Special reassembly procedures are described only when required.
3. Select items from the following index when checks or replacement are required.
Content
l
Disassembly Procedure for each major P.C.B.
................................................................................................................. P.g. 7~11
l
Main Component Replacement Procedures
1. Replacement of the Power IC and Regulator
Transistor........................................................................................ P.g. 12~13
2. Installation of the bottom cover after
replacement....................................................................................................... P.g. 13
6.1 Disassembly Procedure for each major P.C.B.
6.2 Main Component Replacement Procedures
6.2.1 Replacement of the Power IC and Regulator Transistor
6.2.2 Installation of the bottom cover after replacement
TOP PREVIOUS NEXT
pagina 1 van 1
29-11-2012file:///H:/Audio%20nieuw/T/Technics/viewing/SGML_VIEW_DATA/NA/SA-DA15...