Technics SA-EX100 Operating Instructions

FM indoor antenna (included)
This antenna is normally sufficient for reception of FM broadcasts.
FM indoor antenna
{ineluded)
am ‘ Tape
I
‘
‘
FM ANT
nen | ®
Ed
Tore eae ee]
Attach to a wall (using a tack or tape) facing in the direction of best
reception.
For best reception sound quality
An FM outdoor antenna is recommended.
Disconnect the antenna if an FM outdoor antenna is installed.
ee
FM
outdoor
antenna
(not
included)
The outdoor antenna should be used when using the main unit in
mountainous areas or in spaces enclosed by reinforced concrete
where the FM indoor antenna (included) does not provide satisfac-
tory reception.
An
outdoor
antenna
should
be
installed
by
a
qualified
technician
only.
FM outdoor antenna
(not included)
a
75-ohms
coaxial cable
(not included)
300-ohms
Antenna
plug
il
feeder
wire
(included)
(not
included)
(see figure at
the right.) =
-
FM ANT
780.
@
How
to
use
the
antenna
plug
(included)
Two
types
of
wire
are
most
commonly
used
for
connection
from
the
antenna.
300-ohms
parallel
feeder
wire
or
75-ohms
coaxial
cable.
For
best
resistance
to
outside
interference,
the
use
of
75-ohms
coaxial
cable
is
suggested.
To connect a 75-ohms coaxial cable
@
Remove
a
piece
of
the
outer
vinyl
insulator.
=»
20 mm 10mm
@® Remove the cover while pulling the tabs.
If
the
tabs
are
pulled
too
hard,
the
casing
may
be
damaged.
Clamp the cable con-
ductor, and wind it on so
that it doesn’t contact
anything else.
Press down
with pliers.
© Attach the cover.
To connect a 300-ohms feeder wire
300-ohms feeder
wire (not included)
Loosen the screw to connect the feeder
wire and tighten it to secure the connection.

Technics SA-EX100 Specifications

General

Brand	Technics
Model	SA-EX100
Category	Stereo Receiver
Language	English