Technics SA-EX140 Operating Instructions

• r ii "_
PM indoorantenna
(included)
: __,F Adhesive tape
L J
:
Antenna connections
[]
This antenna is normally sufficient for reception of FM broadcasts.
Attach to a wall (using tape) facing in the direction of best reception. •
T
For best reception sound quality
An FM outdoor antenna is recommended.
ha.
This antenna is normally sufficient for reception of AM broadcasts.
Install the AM loop antenna holder (included) at the rear panel of
this unit and then attach the AM loop antenna to the AM loop anten-
na holder (facing in the direction of best reception).
Pay attention to the following points when mounting the anten-
• Do not mount it close to power cords, speaker wires or metal sur-
faces (Doing so will result in noise).
• Do not mount it close to a tape deck. When the tape deck is
being used, chirping or beeping sounds may result.
@J
AM loop antenna
(included)
_]IP i•
]
AMANT
AM LOOP ANT
! I Whenmountingtheantennato a column,a wall or rack[] I
, Mount the antenna so that the hinge is vertical
Screw (included)
m
RQT522'

Technics SA-EX140 Specifications

General

Tuning Range	FM, MW
Input Sensitivity	150 mV
Signal to Noise Ratio	80dB (line)
Dimensions	430 x 125 x 300mm
Speaker Load Impedance	8Ω to 16Ω