Technics SA-GX170 Operating Instructions

To operate a TV
PowERr’™ ~VvCR TUNER
QOJO ©
©)
44 SKE DPF SKP 4i4b >
mode
channel
level
To turn the unit ON/OFF
To select the TV/VIDEO
Press for approx. 2 seconds.
-tv When the unit is turned on, the remote con-
Cy trot will switch to TV operation mode, and
operation of the buttons listed below will be
possible.
The TV screen will change each time the
© button is pressed.
To select the desired
(Example: Channel 9)
1 2 3
9
22Q o
O © © 0 (Example: Channel 12)
To adjust the volume
POWER ty TUNER
Oolojo
vVCR1 TAPE CD
To start play
channel.
To stop play
If you operate a TV, VCR or CD player (or CD changer) using this
remote control, the unit may fail to operate due to the differing
nature of the remote control signal.
If the remote control fails to operate:
It is necessary to switch over the signal within the remote con-
trol by following this simple procedure.
For CD player (or CD changer) operation
POWER cO Press POWER and CD simultaneously, hold
©) O for 2 seconds.
To turn the unit ON/OFF
To select the desired
To fast-forward or
rewind the tape
Press for approx. 2 seconds.
-VCR When the unit is turned on, the remote con-
Cy trol will switch to VCR operation mode, and
operation of the buttons listed below will be
possible.
(Example: Channel 9)
OOO O
4 5 6
SP i) PQ 0 (Example: Channel 12)
1 2
3 cae GD)
In the stop mode
d4uRskip | > PR ESKIP
O
For TV operation
POWER —ty Press POWER and TV simultaneously, hold
C) Ce) for 2 seconds.
For VCR operation
POWER -—vycr Press POWER and VCR simultaneously, hold
C) for 2 seconds.
To restore the previous memory contents, carry out the
same operations one more time.
Depending on the model, there may be cases where operation
is still not possible even if the remote control signal is switched
over due to differences in frequency range characteristics.

Technics SA-GX170 Specifications

General

Brand	Technics
Model	SA-GX170
Category	Stereo Receiver
Language	English