Connection of surround speakers Connection of center speaker
m
Before sound can be heard, the SURROUND mode or 3 STEREO
mode (of the Dolby Pro Logic system) must be on.
Right speaker Left speaker
(not included) (not included)
@® @®
FRONT
(not included)
This unit
®
@
I I
Center speaker
(not included)
CE_IER
N
This unit
:°: I
I I
Center speaker
(not included)
I
This unit
OE_ER FRONT
@
I I
• Speaker impedance
The impedance of any speaker used with this unit must be 8 Q,
Connection of subwoofer
_]r'..1[.et[fl_IIIL _el_.'f,_IU[,] _ii
Rightspeaker Leftspeaker
(not included) (not included)
@® @®
__ _,Speaker cables
/ I_ (not included)
S_D_I I_ .___ _ ThIs unit
=, IIc,.,R,RO,,
ooo ®
®_ o o o _
m
1.
2.
Before sound can be heard, both surround speakers must be
connected.
Do not connect the surround speakers to the front speaker ter-
minals. The surround speakers may be damaged if connected
to the front terminals due to the output power difference bet-
ween the front and surround terminals.
• Speaker Impedance
The impedance of any speaker used with this unit must be 4-8 Q.
The subwoofer is connected when bass sounds are inadequately
reproduced because front speakers are too small.
When connected, the subwoofer can be placed in any position.
This unit has no amplifier section designed especially for the sub-
woofer, so it is necessary to purchase a subwoofer with a built in
amplifier or buy the two separately.
1Subwoofer with built-in
q_ J amplifier (not included)
__ / Stereo connection cable
/
j_l(not included)
-- _ _ This unil
.o.. 0_..0_0II ®®_ ®®=CENTER FRONT
o.o
I I
Connecting a subwooFer which does not have
a built-in amplifier
Connect an optional amplifier to the "SUBWOOFER" terminals of
this unit and then connect a subwoofer to the speaker terminals
of the amplifier.
For your reference:
The level of sound output from the subwoofer will always be at
80 Hz or less, regardless of the settings of the speaker select but-
tons on this unit, thus the intensity of the low frequency range will
be maintained.
When adjusting the volume of the subwoofer
After setting the volume control on the subwoofer or on the
amplifier which is connected to the subwoofer, make any further
adjustments with the volume control on this unit.
11
To Next Page
Loading...
Need help?
General
