jr_v_
• _, . • o e_[_l_
El
18
Adjusting speaker output level
In order to reproduce the movement of the sound and its clear
orientation, it is important to adjust the output level of each
speaker. Adjust output to the correct levels while listening to the
test signal.
TEST
................ ,_-', JQ
1235 4
TEST
T
1
_'_Jo_
_,--,IT°,J;_.:L__'c_
JJ "
4
]"'; s;_i_.s"."".;_4_:,,;;:;,ii,;;,;;:;_I,;_:.,_.i,i.....
or
SPEAKEFI_
Press SPEAKERS and check
the "ON" Indication lights
up.
I/I-I-I I
II I_ I'T I _.,
1
Lights up
";;:;_..,7;,_,i,,_.;,;1_,;,_.,;;;;,;;,,.,_;...................
I suRRou.oi Press SURROUND or
3 STEREO to turn on the
_ desired mode.
or
Pressing the same button again turns
off the activated listening mode.
OOLSV Press PRO LOGIC to turn on
--PRO LOGIC --
[ j the Dolby Pro Logic systems
and select the desired
mode.
......;_s;......Pr.,,_,_i_S_iooui;;ui;,t.,t
I = l signal"
"-'h'_R-"I "_
\ _ I T_-_- T
_J i® I I- "-/ I vc._
The test signal is emitted in the follow-
ing order:
For SURROUND mode
Front speaker-_, Center speaker
(left)1" [
Surround speakers *----Front speaker
(left, right) (right)
The test signal is not emitted from the
center speaker when the center mode
is on PHANTOM.
For 3 STEREO mode
Front speaker _ Center speaker
(left) ,__
--.Front speaker (right)
_" :_o_" "'+.m'"voL0MEio.; "the
volume level normally used
_ for enjoying the
source.
....cE"_E"......Pr.*_,CENTERii0;(+i0r
J - J +j- + SURROUND(-)or(+)toad.
just the output level
_,,,,,__balance.
SURROUND Adjust the output level of each
L,_ peaker from the listening position un-
til they are all identical.
I_: Decrease the output level.
F-F-I: Increase the output level.
® ÷3- .=
Output level canlbe varied within a
range of - 12 dB to + 12 dB according
to that output from the front speakers.
i
[
1. The test signal isoutput only by the
speaker you are now adjusting and
does not repeat the sequence until
adjustments are complete.
2. Remember you cannot adjust out-
put level of the surround speakers
if you selected the 3 stereo mode
in step 2.
TEST
To stop the test signal
J Press TEST.
To Next Page
Loading...
Need help?
General
