Adjusting the delay time
_:/:1[ _e]):trJ_ZolLON,_IOEo],ns!
_[.1_1_, -,,,,Jmh'lk'llJ:| _llll _lltl*]nz s!
Adjust the sound from the surround speakers until the proper ef-
fect is produced.
The diagram below shows SA-GX790.
f
!......!_l/
1 2
;PROIOGIC-II the Dolby Pro Logic systems
I, _ and select the SURROUND
_ mode.
[_" ;._;;.-.....P;..OeLA_iTi,EtO..ito
I _ I the suitable time.
__="= When the button is pressed, the cur-
L \ rent delay time is displayed, pressing
it again changes the delay time.
Lights up
i1--.*
m I --I ,,,
Each time the button is pressed, the
delay time will increase by 5 ms.
To calculate the delay time, refer to
the calculation methods below.
The standard setting is 20 ms.
Front Center Front
speaker (L) speaker speaker (R)
J.
D): Distance from front speakers
D2: Distance from surround speakers
• If D1 Is equal to or less than D=
Set to 15 ms.
• If D= Is less than D1
Start at 15 ms and increase by 5 ms
for every 5 feet of difference bet-
ween D1 and D2.
Enjoying with SURROUND or
3 STEREO
1 2
OFFION THEATER EFFECT
I'
....._-:.. :_;....................
SURROUND I Press SURROUND or
' _' 3 STEREO to turn on the
_ desired mode.
or
I 3STEREO I Pressing the same button again turns
_x_ off the activated listening mode.
DOLBY Press PRO LOGIC to turn on
--PRO LOGIC -
[ I the Dolby Pro Logic systems
and select the desired
_ mode.
................St;;.th.d,;,Imd,,_;.,_e.....
m
When employing SURROUND, use
software recorded in Dolby Surround.
[
OFF,ON To turn off the Dolby
I systems
Press OFF/ON.
Press once again to turn it on.
Pro Logic
To enjoy THEATER EFFECT
UsevideosoftwarerecordedInDolbysurround.
The THEATER EFFECT works only when the surround mode Is
ON.
THEATER EFFECT
Select the surround mode with the
above procedure, and then press
THEATER EFFECT.
Lights up
Pressonce againto turn it off.
19
To Next Page
Loading...
Need help?
General
