104
(Continued)
Load Fail
• The firmware cannot be found on the USB flash
memory.
• Download the latest firmware on the USB flash
memory and try again. (⇒ 92)
No Device
• No USB device is connected.
• Connect the USB device to be played. (⇒ 47)
• The connected USB device is not supported.
• The format of the file on the USB device is not
supported.
For supported formats, refer to “File format”.
(⇒ 115)
No Disc
• No CD is inserted.
• Insert the disc to be played (⇒ 38).
No Network Available
• This unit is not connected to the network.
• Check the network connection. (⇒ 28)
No Play
• The disc cannot be played back.
• Insert the disc to be played (⇒ 106).
Not Valid
• The function you have tried to use is not available
with the current settings. Check the steps and
settings.
Operate via App
• Operation from the unit or remote control is not
available.
• Use the connected device or application for
operating.
PGM Full
• The number of programed tracks is more than 24.
Please Wait
• This is displayed, for example, when this unit is
turned to standby/on. (For up to approx. 1 minute
and 30 seconds)
Reading
• The unit is checking the CD information. After this
display has disappeared, start operating.
“Remote
” (“ ” stands for a number.)
• The remote control and this unit are using
different modes.
Change the mode on the remote control. (⇒ 22)
Searching
• The unit is checking the media server on the
network.
This track is not available.
• Some content may not be available on the music
streaming service, etc.
To Next Page