105
Touch Switch Off
• The touch switch operation of this unit is disabled.
(⇒ 90)
Unlocked
• “OPT” is selected, but no device is connected.
Check the connection with the device. (⇒ 51)
• The sampling frequency components, etc. of the
audio signals are not input correctly.
For supported formats, refer to “File format”
(⇒ 115)
USB Over Current Error
• USB device is drawing too much power.
Disconnect the USB device and turn the unit to
standby and on again. (⇒ 47)
Wi-Fi Setup
• Select “Yes” and press [OK] to enter the network
setting. (⇒ 31)
To exit the network setting, select “No” and
press [OK].
To Next Page
Loading...
Need help?
General
