Technics SC-CH750 User Manual

Edit-Recording
from
Compact
Discs
You can edit up to 20 tracks.
Using the edit-recording safeguards against a break in the continu-
ity of the sound when the recording changes from one side of the
tape to the other.
Before recording, the cassette deck will automatically rewind the
tape
to
the
beginning
and
make
a
non-recorded
passage
of
about
10 seconds, then stop.
So you don't have to set the cassette tape to the starting position
before recording.
In
any
of
the
following
edit-recording
functions,
you
can
record
with
desired
tone
and
effect.
See pages 54-59.
When
playing
back
such
recordings,
press
ON/FLAT
on
the
sound
processor
to
set
to
FLAT.
Sequential CD recording (ALBUM)
The tape length indicated on the cassette tape is slightly shorter
than the actual tape length. In this sequential editing mode, the
cassette deck will fast-forward and rewind the tape in order to make
@
rough
estimate
of
the
tape
length.
After
making
an
estimate,
the
cassette
deck
starts
recording
to
calculate
the
actual
tape
length.
If the system determines it is possible to record one more track on
side A, the cassette deck rewinds the tape side A to the end of the
last track recorded and the first track assigned on the tape side B
will be recorded on the tape side A.
A tape such as follows will be made:
First-arranged
(Side A) | etwack] (and —] [ara] [am Dank
(Side B) | (sm) [en 1 1] ath J
Re-arranged ¥
(Side A) | [tet] [and 1 [3rd] [ath] (sth
(Side
B)
|
~em_
7th
[sth
|
Switch on the power.
1 Loada cassette in deck 2.
Check that the tape’s erasure prevention tabs (see page 75)
are intact, and then insert the cassette into deck 2.
When making a Dolby NR recording, press DOLBY NR to
select “B” or “C”.
2 Press REVERSE MODE to select the “C->”
reverse mode for automatic two-sided re-
cording.
3 Press OPEN/CLOSE to load a disc.

Technics SC-CH750 Specifications

General

Brand	Technics
Model	SC-CH750
Category	Stereo System
Language	English