Technics SC-EH750 - Recording from Radio Broadcasts; Tuning and Recording; Stopping and Interrupting Recording

exroncimnenemmnan
@ OPEN
Q 7 side |
i
DOLBY NR
@REC PAUSE
Recording from radio broadcasts
Preparation:
eThe leader taps in deck 2 must be wound on beforehand.
(™ page 37)
Press [5/1] to tum the unit on.
Press [4 OPEN] on deck 2 and insert the tape
with the exposed part of the tape facing down-
ward.
Close the holder.
To record in Dolby B NR:
Press [DOLBY NR] and check “OO NR” Is dis-
played.
Ei Press [REV MODE] to select the reverse mode.
at One side will record, then recording will stop
automatically.
=, C322: Both sides will record (forward side-»> reverse side),
then recording will stop automatically.
Tune in the desired station.
(= page 15)
Press [@ REC PAUSE] to put the cassette deck
into the recording standby mode.
The playback indicators <J or [> will start flashing.
If you select “c==>” in step the direction will automatically
change to “=>” when you press [@ REC PAUSE].
fa Press [<]] or [[>] to start recording.
>: To begin recording from the forward side.
<1: To begin recording from the reverse side.
To stop recording:
Press [ll].
To display the tape counter while recording:
Press [COUNTER DISPLAY].
The tape counter will be displayed for approximately 5 seconds. This
is a useful way for knowing what point of the tape you're at.
To cut an unnecessary part while recording:
1. Press [@ REC PAUSE).
The cassette deck will go into the recording standby state.
2. To resume recording, press {<J] or [>], whichever playback indi-
cator is flashing,