Technics SC-EH750

Setting the time
This is a 24-hour display clock.
The figure shows how to set the time for 16:25.
Bi
Press
[A]
to
turn
the
unit
on.
FP]
©
Press
[CLOCK/TIMER,
-DEMO]
to
show
“CLOCK”,
Every time you press the button:
CLOCK © PLAY—® REC— Original display
t J
Within 5 seconds:
@ Press [SET].
g
M)
5
%
i)
EI
@
Press
[TUNING
(v
or
~)]
to
set
the
present
time
on
the
display.
The
time
display
can
be
changed
in
one
minute
units
by
tap-
ping
the
buttons,
and
quickly
by
holding
down
the
buttons.
@
Press
[SET].
The
display
will
return
to
the
previous
display
after
about
3
sec-
onds.
To display the clock:
Press [CLOCK/TIMER, -DEMO}.
The time is shown for about five seconds.
The
time
is
shown
constantly
when
the
unit
and
ECO
mode
are
off.
ECO mode n
When
this
mode
is
used
the
power
consumed
when
the
unit
is
switched
to
standby
mode
reduces
from
a
maximum
of
11
W
to
0.6
W
This
mode
is
set
to
on
at
the
time
of
purchase.
NORMAL (off) ECO (on)
Display
Clock
display,
etc.
Blank
Power consumption
in
standby
mode
TW
aoe
The
demonstration
is
shown
if
DEMO
is
on,
regardless
of
the
condi-
tlon
of
the
ECO
mode.
Turn
DEMO
off
if
ECO
is
used.
Turning ECO on and off:
Press [(/] to turn the unit on.
Press [ECO].
The
current
ECO
mode
is
displayed.
Press
again
to
change
the
mode.
The display changes each time the button is pressed:
NORMAL (off)== ECO (on)
When ECO is on:
When
the
power
is
switched
off,
standby
indicator
lights,
but
the
dis-
play
panel
remains
blank.
When
the
unit
is
off,
the
mode
can
be
switched
from
NORMAL
to
ECO,
but
not
the
other
way.
ROT4970