Need help?Do you have a question about the Technics SE-9060 and is the answer not in the manual?
Instructions for attaching optional feet to adjust unit height for stacking.
Guidance on obtaining authorized service for the product.
Information on finding the unit's serial number for record-keeping.
Details the DC amplifier design, dual FETs, and low distortion characteristics.
Explains independent left/right power supplies and constant-voltage design for stability.
Describes circuitry for speaker protection against short-circuits and DC voltage.
Details using the unit as a high-output monaural amplifier via BTL circuitry.
Diagram and explanation for connecting components for stereo use.
Diagrams and instructions for connecting components for monaural use.
Explains the power switch and indicator light for unit operation status.
Controls for turning speaker systems connected to MAIN or REMOTE terminals on/off.
Illuminates to indicate BTL operation when the switch is set to MONO (BTL).
Connection port for headphones, with impedance guidelines.
Selects between DC operation and low-cut (2 Hz) for optimal performance.
Adjusts input level sensitivity for optimal performance and noise reduction.
Important checks before making connections, including switch settings.
How to connect speaker systems to MAIN and REMOTE terminals.
Recommendations for optimal speaker placement for sound quality.
Guidelines for connecting the preamplifier and input terminals.
Information on suitable speaker impedances and wiring gauge.
Pre-operation checks for connected equipment and unit settings.
How to select program source and adjust volume for playback.
Using the front panel pushbutton to control MAIN speakers.
How to adjust input level using the front panel control.
Information on the AC outlet's capacity and usage restrictions.
Notes on headphone usage with MONO (BTL) mode.
How to connect the SH-9020 meter unit for BTL operation.
How to set impedance correction on the SH-9020 for BTL output readings.
Graph showing total harmonic distortion versus output power in stereo mode.
Graph showing total harmonic distortion versus output power in monaural mode.
Graph showing total harmonic distortion across frequency for power bandwidth.
Graph showing output power at different load impedances for stereo and mono.
Graphs showing gain and phase response with different low-cut settings.
Specifies power output for stereo and monaural modes.
Specifies continuous power output at 1 kHz for stereo and monaural.
Lists total harmonic distortion ratings at rated and half power.
Specifies intermodulation distortion at rated power.
Lists frequency response ranges and tolerances.
Signal-to-noise ratio measurement using IHF A-weighting.
Specifies residual hum and noise levels.
Details input sensitivity and impedance requirements.
Specifies the damping factor of the unit.
Lists recommended load impedances for stereo and monaural operation.
States power consumption and required power supply specifications.
Provides the physical dimensions and weight of the unit.
Lists included accessories like connection cords, feet, and screws.
Warning about using the correct voltage and avoiding DC sources.
Information on the AC outlet's capacity and usage restrictions.
Safety precautions for connecting and disconnecting the power cord.
Advice on placing the unit away from direct sunlight and heat sources.
Safety advice regarding children, small items, outlets, and insecticides.
Instructions for water spills and warnings against unit modification.
Reminder to always turn off the power after use for safety and longevity.
To Next Page
General
