Need help?Do you have a question about the Technics SE-A1010 and is the answer not in the manual?
General| Damping Factor | 100 |
|---|---|
| Signal-to-Noise Ratio | 110 dB |
| Speaker Load Impedance | 4Ω to 16Ω |
| Type | Stereo Amplifier |
| Frequency Response | 5Hz-100kHz (±1dB) |
Procedure for safely discharging power supply capacitors before servicing.
Steps to take when the protection circuitry activates.
Instructions for safely replacing the fuse in the mains plug.
Caution regarding unsuitable plugs and safe disposal.
Instructions for connecting speakers, including impedance considerations.
Step-by-step guide for checking the main printed circuit board.
Detailed steps for replacing the meter assembly.
Instructions for removing and replacing the cooling fan motor.
Procedures for replacing key internal components.
Procedure for replacing the power IC and regulator transistor.
Key to symbols, voltage lines, and important safety notices for schematics.
Step-by-step guide to calibrate the power meters.
To Next Page
