Technics SH-AC500D

SH-AC500D
li Speaker setting
Set the types and presence of the speakers before enjoying the
sound by reproducing the input source.
Before proceeding:
Check the frequency range of each speaker to be used. Consider
speakers capable of playing back low frequency sounds (below
around
100
Hz)
as
LARGE.
Consider
speakers
not
capable
of
playing back low frequency sounds as SMALL.
Press POWER.
owaon
Press
CHANNEL/SET,
and
select
the
channel
for
which
the
speaker
is
to
be
set.
becoescucccavceconvesoen
wepececococvevecerossgsn0e
Keene
Bevecseosvocensceace
Each
time
the
button
is
pressed,
the
channel
display
is
SPEAKER
SETTING
switched
in
the
listed
order.
CHANNEUSET
FRONT:
Front
speakers
CENTER:
Center
speaker
SURROUND: Surround speaker SUB-WFR: Subwoofer
COMPLETE: Select this when you have completed the
settings.
The selected channel is shown on the display for approx. 2
seconds. The current setting for that channel is then shown
as a flashing display. The indicator corresponding to the
selected speaker also continues to flash.
Press SELECTOR, and set the type (LARGE,
SMALL) and presence (YES, NO or NONE) of
the speaker.
Each time the button is pressed, the display is switched in the
listed order.
LARGE: select if the speaker can produce low frequency
sounds,
SMALL: select if the speaker cannot produce low frequency
sounds,
NONE: select if you are not using a center speaker or
surround speakers,
YES: select if you are using a subwoofer,
NO: select if you are not using a subwoofer.
The sound for speaker channels that are set to “NONE” or
“NO” are output from the front speakers. DTS format
software, however, depends upon all channels being
operable, and so the sound for speakers not connected is not
heard at all, no matter what settings are made.
SELECTOR
Repeat steps 2 and 3 to complete the settings
\
for
all
the
channels.
Press CHANNEL/SET to select “COMPLETE”.
(FRONT)|
LARGE
SMALL
The
settings
are
now
entered
into
the
unit’s
memory.
The
display goes out after about 2 seconds and the previous
(CENTER) | LARGE NONE
display reappears.
The speaker indicators light up unless “NONE” or “NO” has
been selected for the corresponding channel.
(SURROUND) [LARGE |—-[SMALL}—-[ NONE ]} [Ee
If no buttons are pressed for approx. 10 seconds during the setting
process, ail previous settings are canceled, the setting mode is
SUB-WER
released,
and
the
original
display
is
restored.
(
)
YES
NO
Begin
the
setting
process
again
if
this
occurs.
For your reference:
The setting remains as it is until changed by the above procedure,
even after the power has been turned off.