Technics SL-3300 User Manual

7 Dust and dirt should be carefully removed from stylus tip
or records.
Dust and dirt on the stylus tip or record may not only result
in deterioration of to ne quality , but also cause undue wear of
the record and the stylus tip itself .
Special
stylus ti p brushes and record cleaners ca n be purchased
in most ele ctr onic supply houses.
8 Wipe th e dust cover and turntable base with a soft, dry cloth.
Never use
any cleaners containing alcohol, benzine or thinner .
Use of a
chemical dust cloth should also be avoided. Be sure
that the dust cover is not exposed to insecticide spray.
To remove stubborn finger prints or grease spots, detach the
dust cover and disconnect the AC power plug .
Use a soft cloth slightly moistened with a mild soap and water
solution.
Do not wipe the dust cover during play, or the tonearm may
be attracted toward the dust cover due to the generation of static
.elec tricity .
9 Lubrication
Apply 2 or 3 drops of oil once after every 2000 hours of opera-
tion . (See Fig. 24.)
The
t1me 1nterval is much longer than that for conventional t ype
motors (2 00 - 500 hours) .
Please use
only the special oil for this turntable (part number
SFWO 01 0) which you can purchase from any Authorized
Panasonic Parts Distributor .
oil
Adjustments
0 Adjustment of arm-lift height (See Figs. 25 and 26.)
- 7 -
The arm-lift height (distance between the stylus tip and record
surface when cueing knob is at the ".!_"position) has been adjust-
ed at the factory before shipment to approximately 5 to 10 mm.
5-10 mm
For using different cartridges available on the market or when
further adjustments are particularly necessary , make adjustment
as foll ows:
Turn the adjustment screw clockwise or counterclockwise, while
pushing the arm lift down.
Clockwise rotation
-
distance between the record and stylus tip is reduced.
Counterclockwise rotation
-
distance between the r ecord and stylus tip is increased .
Note:
•
As the adjus tin g screw has a hexagonal head, be sure to
mak e the adjustment wh ile depressing th e arm li ft , or th e
screw will not move fr ee ly .
Also be s ure th at th e hexagonal head re tr acts correc tly int o
th e arm lift when the latter is released .

Technics SL-3300 Specifications

General

Drive Type	Direct Drive
Motor	Brushless DC motor
Effective length	230 mm
Overhang	15 mm
Stylus pressure adjustment range	0 to 2.5 g
Speeds	33, 45 rpm
Platter	Aluminum die-cast
Tonearm Type	Universal
Rumble	-75 dB (DIN-B)
Cartridge weight range	4-10 g
Wow and Flutter	0.025% (WRMS)
Signal to Noise Ratio	78 dB