Technics SL-J33 - Page 3

Connections
Stylus-set-down-position
adjustment screw
This has been preset at the
factory and should not
require readjustment.
Synchro-recording/remote e————
control terminal
This terminal can be connected
to a Technics amplifier or
cassette deck which has
synchro-record output.
It can also be connected to the
“remote-control to phono”
terminal
of
a
Technics
amplifier
or
receiver.
(Refer
to
the
operating
instructions
of
each
unit.)
nEwoTE
(R)
(GND)
This
unit
AC power supply cord (included)
Stereo connection cable
(included) se
' Household AC outlet
=
(AC
120V/60
Hz)
Ground
wire
(included)
,
If
the
ground
wire
is
not
F
connected,
a
“hum”
noise
may
i
H
T
(R)(L)
be
heard.
Connection
cable
for
remote
——|
control
(included)
AC
OUTLET
Amplifier or Receiver (option)
Turntable
Assembly
1.
Remove
the
packing
spacers.
3.
Attach
a
(14D)
cartridge
(option).
(Ta)
is
the
standard
mark
for
the
“P-mount”
plug-in-
connector
system.
Products
carrying
this
mark
are
interchangeable
and
compatible
with
each
other.
Installation: (Refer to page 4.)
1.
Place
a
30
cm
(12”)
disc
on
the
platter
mat
and
close
the
upper
cabinet.
2.
Press
the
power
switch
to
turn
on
the
electrical
power
supply
of this unit. (The tonearm will move inward automatically.)
3.
When
the
tonearm
moves
over
to
about
the
25
cm
(10”)
position,
press
the
power
switch
to
turn
off.
4.
Open
the
upper
cabinet,
then
attach
a
[Tgp]
cartridge
(option)
as
shown
below.
Turn to left
and remove
} (2 pieces)
using a
ree material like
the coin.
@® Remove the
Store
them
for
future
packing.
©
Insert
the
cartridge
¥
(option).
2.
Place
the
platter
mat
on
the
platter.
Use
only
the
included
platter
mat.
Platter
mat
© Tighten the
/y
screw.
Platter