Adjusting the output level of each speaker
In order to reproduce the movement of the sound and its clear ori-
entation, it is important to adjust the output level of each speaker.
Adjust output to the correct levels while listening to the test signal.
For surround mode
L --_ C ---* R _S
1" I
• If front speaker volume is unbalanced, adjust the balance with the
BALANCE.
21 3 5 4
J
©
OFF/ON
u
SI'E'_KERS...... Press sPEAKERSiotum On ......
the front speaker systems.
SPEiKERS /
Illuminates
In the PHANTOM mode, the center
speaker is OFF, so the test signal is not
output and "C" is not displayed.
For 3 STEREO mode
L -_- C--=- R
+_ J
..... VOLUME Turn voLUME tO setthe Vol-....
_/_'_ ume level normally used for
_ enjoying the source.
. -_,N_R - PressCENTER(=) o;i+) or.........
SURROUND (-) or (+) to
"_ :dj::t the output level bal-
k."]l]=1r,[m]ll]_It]r_,_ F_J_;3';1_
SURROUND While standing in the listening area,
_ djust the output levels of each speaker
until they are all identical.
r_ Decrease the output level.
Increase the output level,
COLBY Press DOLBY PRO LOGIC toPRoLOGpC turn on the Dolby Pro Logic
[_ system and select the desired
mode.
For SURROUND mode
I
m.
For 3 STEREO mode
QD_St--=RSO
--I "--I I i--i_ #--# i
[_ _ Press TEST to output a test
signal.
"J-l--l-- T I I
I(_ ll I )
I
k t tt" th t t ] I
Thespea eroupu mg e es s=gna is
displayed while the test is running.
L : Front speaker (left)
C : Center speaker
R : Front speaker (right)
S : Surround speakers
'5 +_--,'d21
Output level can be var ed within a
range of -12 dS to +12 dB with front
speaker output level serving as the zero
point.
The test signal is output only by the speaker you are
now adjusting and does not repeat the sequence until
adjustments are complete.
To stop the test signal
Press TEST,
To turn off the Dolby Pro Logic systems
OFF/ON
_) Press OFF/ON.
Press once again to turn it on.
43
To Next Page
Loading...
Need help?
General
