Technics SL-MC6

Receiver or
amplifier
@®@
faegeneg
Red (A) <i
: To household
les ouilet
SS)!
~
R6/LRG, AA,
UM-3
‘Check the (+) and (~)
| sides.
remeron
af
Connections
® Set the changer on a flat, level surface.
© Before connecting the changer to your audio system, make sure
that the power of the changer and all other system components is
turned off.
(For United Kingdom onty)
BE SURE TO READ THE CAUTION FOR THE
AC MAINS LEAD ON PAGE 3 BEFORE THE
FOLLOWING CONNECTIONS.
Insertion of Connector:
Even when the connector is per-
fectly inserted, depending on the
type of inlet used, the front part of
the connector may jut out as shown
in the drawing.
However there is no problem using
the unit.
Approx. 6 mm
Memory retention
The information and presetting you enter is retained in the unit's
memory even if the unit is disconnected from the AC power source.
The period of retention for each type of information is as follows:
®
program
play
(mp
page
10)
and
disc
grouping
play
(m
page
14);
approximately
one
week
@ text editing (mp page 19); unlimited.
Preparing the remote control
¢Do not mix old and new batteries, or batteries of different types
(carbon and alkaline, etc.).
* Never subject batteries to excessive heat or flame; do not attempt
to disassemble them; and be sure they are not short-circuited.
@ If the remote control is not to be used for a long period of time,
remove the batteries and store them in a cool, dark place.
@ Do not attempt to recharge alkaline or carbon batteries.
© Do not use rechargeable type batteries.
Use the remote control within 60 degrees and within 7 meters facing
toward the unit.
Operation notes
@ Aim the remote control’s transmission window toward the unit’s
sensor. Avoid any obstacles.
© Be sure the transmission window and the unit's sensor are free
from dust. Excessive dust might affect performance.
© Do not expose the remote cotrol signal sensor to direct suntight or
to the bright light of an inverter fluorescent light.
To prevent damage
@ Never place heavy items on top of the unit.
# Do not disassemble or reconstruct the unit.
* Do not spilt water or other liquids into the unit.