Technics SL-P200 Service Manual

| SL-P200_
Drive belt
sac a How to remove the loading motor
How to remove the main P.C.B.
How to check the main P.C.B.
Procedure | 4 Remove the 4 screws. When checking the soidered surface 1. Push the rack gear slowly in the direc-
1>6—8 | 2 Lift the P.C.B. remove it from the of the main P.C.B. and replacing the 1>2>11 tion of the arrow until the disc tray
chassis tab. parts, do as shown. comes up.
3. Remove the P.C.B. in the direction of Cautions: . Pull the disc holder until it stops.
the arrow. . Remove the drive belt.
eBe sure to connect the P.C.B. ground
terminal (line out terminal) and the
chassis with a lead wire.
Be sure to connect the GND lead wire
CN11 t from the loading base to the chassis.
. Remove the 2 screws.
. Release the claws. oO & & DY
a ole.
=)
Disc
holder—__
Disc
tray
Lead wire
How to remove the spindle motor
Tet
[Ly Main P.C.B.
CN401
2)
Procedure
1-2-3-4
—+9—12
1. Loosen the screw (@) by using a
1.27mm hexagonal wrench and remove
the turntable.
2. Remove the 2 screws (@, ®).
CN402
Caution:
1. Turntable height adjustment is necessary any
time the turntable or spindle motor is replaced.
2. The (+) terminal of the spindle motor is indicated
by the red mark.
Adjustment of turntable height
1. Insert a 0.9mm feeler gauge (RZZ0297) between the
Ref. No. | How to remove the servo P.C.B. Ref. No.
and loading motor P.C.B. How to remove the optical pickup
9 turntable and loading base as shown below.
Procedure Procedure 7 '
1+2-+3-4| A. Servo P.C.B. 1> ee rd 4! | Refer to the optical pickup handling Tormable ae Spindle motor
8 1. Remove the 3 screws (O~®). —s= precautions and instructions for the 0.9mm / 22mm feeler
2. Unsolder the 2 terminals of spindle oil (See page 6). cE atin ; gauge (RZZ0297)
motor. UN
a
EE
|
(+)
Terminal
1. Remove the 2 screws (@, @).
|
Spindle motor
2. Unsolder the 2 terminals and the 2
screws (@, ©).
3. Remove the FPC board from the
optical pickup.
Caution:
Insert the short pin into the FPC board
in order to pervent breakdown of laser
diode. (Refer to page 6)
B. Loading motor P.C.B.
1. Remove the 2 screws (@, @).
2. Tighten the turntable set-screw by using a 1.27mm
hexagonal wrench.
Optical
pickup
Cauti
aution:
Refer to optical pickup adjustment (see page 16).
ares How to remove the power transformer
rocedure
F hade aah 1. Remove the connector (CN1).
Loading =>13 2. Remove the 2 screws.
motor
3.
Release
the
Tab.
Spindle
motor
terminals
Terminals
Brush terminal
Caution: Take care not to
touch the brush terminal.
—9— —10—

Technics SL-P200 Specifications

General

Brand	Technics
Model	SL-P200
Category	CD Player
Language	English