Technics SL-PG340 - Program Playback; Programming Tracks

Program Play
3
2
1
PROGRAM
PROGRAM
STOP
5
4
You can program up to 20 tracks in any order you desire.
PGM
If you enter a wrong number by mistake, press CLEAR.
1
PGM
1Z3.J.16789 10 11 12
►H SKIP
PGM
12.21567021011 12 13 14 15 16 J>
5
12
Repeat steps
2, and 3 as
desired.
Number of
programmed tracks
The last track in
programmed order
TA
<_"/ 3
L- No.
1 2 3 4 5 6 7
6
7
When the 21st program has been performed, the following
display indicates that no more tracks can be added.
I
■ n»« npt
C.i . > .M*. X
I 1 ------- =11 1[ —
Before beginning, follow steps 1-3 of “ Basic Oper 
ating Procedure ” on page 8.
1 in the stop mode, press PROGRAM.
If you press this button in the play mode, the track in play will be
programmed.
Illuminates
| PGM
RECALL
-rn
CLEAR
3 Press PROGRAM.
4 Repeat steps 2 and 3 until the desired program
is completed.
For example, if you enter tracks 5.3 and 2:
If the total playing time exceeds 99 minutes 59 seconds or if the
track number 21 or higher has been specified, the display reads
as follows:
Press ► PLAY to start.
The unit stops automatically when all the programmed tracks
have finished playing.
3 / EG
L_ I No.
Total playing time of
programmed tracks
I-I I U -I
I _(• II
n 0
U NO.
2 3
8 9 10 11 12
4 5
8 9 10 11 12
2 Press SKIP (K<, »l) to select the track num 
ber.
For example: To select the 3rd track, press
3 times.
Even after play is completed, the program sequence will remain in the
unit's memory. You can play the sequence again by pressing
► PLAY.