Technics SL-PG340 - Program Management

This clears all programmed contents from memory.
To confirm the program
PGM
PGM
PGM
The normal display will resume in about 4 seconds.
To enter additional tracks
To clear the entry
CLEAR
13
Each time you press RECALL, the display shows programmed track
number and its sequence, so that you can verify the entire program.
Press once in the stop mode and twice during play.
This clears all programmed contents from memory.
Turning off the power will also cancel the program play mode.
To switch to sequential mode during play
Press PROGRAM.
PROGRAM
Press RECALL.
RECALL
In the stop mode, press SKIP ( |«, ) to specify
the track number and then press PROGRAM.
(See page 12.)
To clear the last track in the sequence, press
CLEAR in the stop mode.
CLEAR
To cancel all the programmed tracks, press
PROGRAM twice in the stop mode and return to
step 2 on the previous page.
PROGRAM
To cancel a track in the middle of the sequence,
press RECALL repeatedly until the display shows
the track number to be cancelled, then press
CLEAR.
RECALL
For example: The diagram shows a program consisting of tracks
5,3,2.
Press RECALL.
o
Press RECALL
again.
7 8
Programmed track number
Programmed sequence
—
To cancel the program play mode
Press ■ STOP.
stop ^~|
r
-J No.
, I 3 < S 6
3 3
I — No.
1 II « I ■
9 10 11 Q
8 9 10 11 12
3 ?
— ' No.
123 4 567B9>0Ut2
o
Press RECALL
again.
o
____ )