Technics SL-PG420A - Page 8

Ref. No.
9
Removal of the disc holder
8
Procedure Procedure
1-7-8 1>2>7-9 Bracket
of tray
Sw(SIOO!)
1. Pull the disc holder slowly in the direction of the
arrow until the disc tray comes up.
2. Pull the disc holder until it stops.
3. Push the bracket of tray SW (S1001) in the direction
of the arrow.
4. Pull out the disc holder further to remove it.
1. Pull out the holder in the direction of the arrow (®).
2. Remove the ring in the direction of the arrow (@)..
Caution: Be sure to handle the smail ball carefully.
Ref. No.
Removal of the loading unit Removal of the servo P.C.B.
11
Procedure Procedure
1-2-7 1-2-7
9-10 9-10-11
1. Remove the 4 screws (O~@).
2. Remove the FPC board (CN101) from the optical
pickup.
3. Remove the 1 connector (CN102) of the turntable
motor.
Caution: To prevent the breakdown of the laser diode,
antistatic shorting pin is inserted into the FPC
board.
1. Remove the 3 screws (@~®).
2. Remove the 3 connectors (CN12, CN401, CN431).
Procedure
1-2-7
—9-12
/ 3. Unsolder the 2 terminals of the lead wire of the
1. Remove the drive belt. ; loading motor.
—- 8—