Technics SL-PG440 User Manual

To cancel the edit mode
Press ■ STOP after recording has finished.
STOP |
How to prepare the cassette deck for
recording
1. Insert the cassette tape into the cassette holder of the deck for
the synchro-edit-recording. (Be sure the tape is rewound.)
2. Select the noise-reduction system and the reverse mode
( Ct3)-
3. Check to be sure that the forward-side indicator ( ► ) of the deck
to be used is illuminated.
4. Set the cassette deck to the recording standby mode.
(Refer to operating instructions for the cassette deck to be used.)
If the cassette deck has no SYNCHRO
EDIT terminal
To enter desired recording time other
than 46, 60 or 90 minutes
Press TAPE LENGTH to select “C-” then press
the numeric buttons to enter the tape’s total play¬
ing time in minutes.
TAPE LENGTH
o
>10 01234 56789 10
□□□□□□□□□□□ a
For example:
To enter C-52, press 5 then 2.
If you make a mistake, select "C-” again and enter the correct
number.
Press the play button of the cassette deck at the
same time as pressing ► PLAY on the CD player
to start recording.
•When the deck has reverse mode, set to one-way ( T~~* ).
•When the recording for side A is finished, the CD player will go to
the pause mode. The cassette deck will keep recording.
•To record on side B, first press the stop button on the cassette
deck, then start recording again on side B while at the same time
pressing ► PLAY on the CD player.
21

Technics SL-PG440 Specifications

General

Brand	Technics
Model	SL-PG440
Category	CD Player
Language	English