Technics SL-PG440 User Manual

Connections
1 Connect the stereo connection cable (in¬
cluded) to the “CD” or “AUX” terminals of the
amplifier.
2 Connect the synchro edit cable (included with
the cassette deck) to the “SYNCHRO EDIT”
terminal of the Technics cassette deck.
For areas except Australia and New Zealand
Set the voltage selector (VOLT ADJ) to the vol¬
tage setting for the area in which the unit will be
used.
•Use a minus (-) screwdriver.
•Note that this unit will be seriously damaged if this setting is not
made correctly.
•If the power supply in your area is 117 V or 120 V, set to the
“127 V” position.
3 C onnect the AC power supply cord (included)
to the “AC OUTLET” of the amplifier or the
household AC outlet.
For areas except Australia and New Zealand
If the power plug will not fit your socket, use the power plug
adaptor (included).
Insertion of Connector
Even when the connector is per¬
fectly inserted, depending on the
type of inlet used, the front part of
the connector may jut out as
shown in the drawing.
However there is no problem
using the unit.
5

Technics SL-PG440 Specifications

General

Brand	Technics
Model	SL-PG440
Category	CD Player
Language	English