Technics SL-PG590 User Manual

TAPE LENGTH
arbitrary tape length
\7 > C-46 > C-60 > C-90 > cl >
\
4
Number of tracks on side A
Last track on side A Time remaining on side A
PEAK SEARCH
TRACK : INDEX |: | MIN: SEC
PGM ‘
PEAK G ! ap fel
i
“gpir £42 3 4B 6 7°89 10 41 12.13.14
TAPE LENGTH
CD edit recording is a function which allows you to specify a tape
length and then automatically performs editing such that no tracks
get cut off at the end of the tape.
With this function, an interval is automatically added between tracks
if an interval doesn’t already exist. This is so tape search functions
that use 4 second intervals to find the beginnings of tracks will work
correctly. (auto space function)
il Prepare the cassette deck.
1. Wind the leader tape and insert the tape.
2. Select noise reduction.
3. (Double-side playback decks only)
Set the reverse mode to single side playback ( =— ), and set
the running direction of the tape to > .
4. Set the cassette deck to recording standby mode.
(For details, refer to the operating instructions for the cassette
deck.)
2 | Press TAPE LENGTH to specify the tape length.
This function divides the tracks on a disc between the two sides
of a tape.
Each time the button is pressed, the tape length changes as
illustrated.
©To select an arbitrary recording length, see below.
¢To add tracks in the extra space on the tape, see page 14.
To check the edit contents for side B or make changes, press
SIDE A/B.
E] Press PEAK SEARCH to search for the peak level
on the disc, and adjust the recording level on
the cassette deck.
(see page 12)
4 Press Ml.
Press > at the same time you begin recording
on the cassette deck.
When the tracks allotted to side A have been recorded:
The CD player pauses at the beginning of the first track on side B.
The cassette deck continues to record to the end of side A and then
stops automatically.
*To record side B:
1.Remove the tape to wind the leader.
2.(For a double-side playback deck)
Re-insert the tape and set the running direction to <4.
(For a single-side playback deck)
Turn the tape around and re-insert it.
3.Press ® at the same time you begin recording on the cassette
deck.
To cancel CD edit mode
Press @.
| To select an arbitrary recording length J
Press TAPE LENGTH to select “C---” and enter the
total time for both sides of the tape (1 to 99 min-
utes).
For example
To select 30 minutes: 3 > 0
To select 5 minutes: 0 > 5
If you make a mistake when entering this value, select “C---” again.
(Continued on next page)

Technics SL-PG590 Specifications

General

Type	CD Player
Frequency Response	2 Hz - 20 kHz
Digital Outputs	Optical
Power Consumption	12W
Digital to Analog Converter	1-bit DAC
Disc Format	CD
Digital Converter	MASH
Line Output	2V