Technics SL-PG590 User Manual

(For United Kingdom)
(“EB” area code model only)
For your safety, please read the following text
carefully.
This appliance is supplied with a moulded three pin
mains plug for your safety and convenience.
A 5-ampere fuse is fitted in this plug.
Should
the
fuse
need
to
be
replaced
please
ensure
that
the
replacement
fuse
has
a
rating
of
5-ampere
and
that
it
is
approved
by
ASTA
or BSI
to
BS1362.
Check
for
the
ASTA
mark
@
or
the
BSI
mark
Y
on
the
body
of
the
fuse.
If the plug contains a removable fuse cover you must
ensure that it is refitted when the fuse is replaced.
If you lose the fuse cover the plug must not be used
until a replacement cover is obtained.
A
replacement
fuse
cover
can
be
purchased
from
your
local
dealer.
CAUTION!
IF THE FITTED MOULDED PLUG IS UNSUIT-
ABLE FOR THE SOCKET OUTLET IN YOUR
HOME THEN THE FUSE SHOULD BE RE-
MOVED AND THE PLUG CUT OFF AND DIS-
POSED OF SAFELY.
THERE IS A DANGER OF SEVERE ELECTRI-
CAL
SHOCK
IF
THE
CUT
OFF
PLUG
IS
IN-
SERTED INTO ANY 13-AMPERE SOCKET.
If
a
new
plug
is
to
be
fitted
please
observe
the
wiring
code
as
shown
below.
If
in
any
doubt
please
consult
a
qualified
electrician.
IMPORTANT
The
wires
in
this
mains
lead
are
coloured
in
accor-
dance
with
the
following
code:
Blue: Neutral, Brown: Live.
As these colours may not correspond with the
coloured
markings
identifying
the
terminals
in
your
plug, proceed as follows:
The
wire
which
is
coloured
Blue
must
be
connected
to
the
terminal
which
is
marked
with
the
letter
N
or
col-
oured
Black
or Blue.
The wire which is coloured Brown must be connected
to
the
terminal
which
is
marked
with
the
letter
L
or
coloured Brown or Red.
WARNING: DO NOT CONNECT EITHER WIRE TO
THE EARTH TERMINAL WHICH IS MARKED WITH
THE LETTER E, BY THE EARTH SYMBOL — OR
COLOURED GREEN OR GREEN/YELLOW.
THIS PLUG IS NOT WATERPROOF—KEEP DRY.
Before use
Remove the connector cover.
How to replace the fuse
The location of the fuse differ according to the type of
AC
mains
plug
(figures
A
and
B).
Confirm
the
AC
mains plug fitted and follow the instructions below.
Illustrations may differ from actual AC mains plug.
1. Open the fuse cover with a screwdriver.
Figure A
Figure B
2. Replace the fuse and close or attach the fuse
cover.
Figure A
Fuse
s.
Cs (5 ampere)
( Fuse
(5 ampere)
Figure B

Technics SL-PG590 Specifications

General

Type	CD Player
Frequency Response	2 Hz - 20 kHz
Digital Outputs	Optical
Power Consumption	12W
Digital to Analog Converter	1-bit DAC
Disc Format	CD
Digital Converter	MASH
Line Output	2V