Technics SL-PJ27 - Page 4

SL-PJ27
MI
LOCATION
OF
CONTROLS
ore athe
rN
HIGH SPEED ACCESS SYSTEM
Control section
@ Power switch (POWER HOFF =ON)
@ Disc holder
© Time mode select button (TIME MODE)
Use this button to select the desired time display mode.
4) Buttons for program function
eProgrammed-play button (PROGRAM)
Pressing this button initiates the programmed play mode.
You can then enter specific tracks using the skip buttons.
Clear button (CLEAR)
Each pressing this button makes one track cleared from the
programmed sequence.
© Search buttons (<< SEARCH PP)
These buttons can be used to move rapidly forward or
backward on the disc during play. The search speed is slow
when the button is pressed at first and becomes faster if the
button is pressed and held continuously.
© Skip buttons (<< SKIP >)
These buttons can be used to specify the number of the
desired track and the desired recording time of the tape.
© Repeat button (REPEAT)
© Buttons for CD edit function (CD EDIT)
*Edit tape length button
(EDIT TAPE LENGTH)
When compact discs are to be recorded to tape, this button
can
be
used
to
calculate
the
number
of
tracks
that
can
be
recorded
on
each
side
of
the
tape,
depending
on
the
length
of
the
cassette
tape
used,
so
that
as
little
tape
as
possible
is
wasted.
¢Tape-side select button (TAPE SIDE AB)
When
recording
compact
discs
to
tape,
this
button
can
be
used to check the number of tracks and amount of tape left
over for side A or B.
© Auto cue button (AUTO CUE)
Pressing
this
button
causes
the
unit
to
skip
automatically
to
the
beginning
of
the
next
track
on
the
disc
and
switch
to
the
play standby mode.
@® Play button (> PLAY)
@® Pause button (11 PAUSE)
@® Stop button (™ STOP)
This
button
can
be
used
to
stop
the
disc
play,
as
well
as
to
cancel
the
various
play
modes.
® Disc holder open/close button
(4 OPEN/CLOSE)