Technics ST-GT350 Operating Instructions

_* or AM broadcasts
To change the AM frequency step:
The AM frequency step is set to 9 kHz before
shipment. To change to 10 kHz per step, press
and hold the band select button for 4 seconds
white the “AM” of the band indicator is Il¬
luminated.
TUNING MODE
Press TUNING MODE to select the
desired tuning mode, “AUTO” or
“MANUAL”.
Each time the button is pressed, the position of the
tuning mode indicator <4 mark wilt change as
follows.
FM
PH r J
/ l n
t ' 1 LJ MHz 1
AUTO^j
MANUAL 1
LOCK |
Tuning mode indicators
AUTO -* MANUAL LOCK
AUTO : To automatically tune to the desired frequency in step 4.
MANUAL : To manually tune to the desired frequency in step 4.
TUNING
Turn TUNING control so as to tune to
the desired frequency.
DOWN : To tune to a lower frequency.
UP : To tune to a higher frequency.
STB
FM
IS) _ _
u u
u u.
i n w
1 Urn*
QUARTZ LOCK
AUTO«*
MANUAL
LOCK
Illuminates when
receiving an FM stereo
broadcast
Illuminates when
tuned precisely
Automatic tuning (when “AUTO" is selected in step 3)
The frequency will begin to change when the TUNING control is turned, and then automatically slop when
a broadcast frequency with good reception is found.
Manual tuning (when “MANUAL" is selected in step 3)
The frequency will change only by the amount that the TUNING control is turned.

Technics ST-GT350 Specifications

General

Brand	Technics
Model	ST-GT350
Category	Tuner
Language	English