Technics SU-G700M2 Owner's Manual

25
English
Firmware updates
Settings
(25)
Firmware updates
“F/W Update”
Occasionally, Panasonic may release updated
firmware for this unit that may add or improve
the way a feature operates. These updates are
available free of charge.
• For the update information, refer to the
following website.
www.technics.com/support/firmware/
Downloading takes approx. 5 minutes.
Do not disconnect the AC power supply
cord or turn this unit to standby while
updating.
Do not disconnect the USB flash memory
while updating.
• The progress is displayed as “Updating
%”
while updating. (“ ” stands for a number.)
Note
• During the update process, no other operations
can be performed.
• If there are no updates, “Firmware is Up To
Date” is displayed. (No need to update it.)
• Updating the firmware may reset the settings
of this unit.
■ Preparation
• Download the latest firmware on the USB flash
memory. For details, refer to the following
website.
www.technics.com/support/firmware/
1 Connect the USB flash memory with
new firmware.
2 Press [AMP].
3 Press [SETUP].
4 Press [
], [ ] repeatedly to select
“F/W Update” and then press [OK].
5 Press [
], [ ] to select “Yes” and then
press [OK].
• The progress is displayed as “Updating %”
while updating. (“ ” stands for a number.)
• When the update has finished successfully,
“Success” is displayed.
6 After “Success” is displayed, press
the standby/on button on this unit,
disconnect the AC power supply cord
and USB flash memory.
7 Reconnect the AC power supply cord
after 3 minutes.
Note
• The update may have failed in the following
cases.
- “Updating” is not displayed for 5 minutes or
more.
- The progress display (%) stops for 5 minutes
or more
In case of update failure, disconnect the AC
power supply cord after turning this unit off,
reconnect it after 3 minutes and update again
with another USB flash memory.
• Downloading may take longer depending on
the USB flash memory.
• Use a USB flash memory with FAT16 or FAT32
format.
• UPDATE terminal is used only for firmware
updating. Do not connect any USB device
other than the USB flash memory for firmware
updating.
• No USB device can be charged from the
UPDATE terminal of this unit.

Technics SU-G700M2 Specifications

General

Output Power (8 Ohms)	70 W + 70 W
Output Power (4 Ohms)	140 W + 140 W
Analog Outputs	1 x Line
USB-B Input	Yes
Coaxial Digital Input	1
Headphone Output	Yes
Input Sensitivity	200 mV
Input Impedance	47 kOhms
Load Impedance	4 Ω - 16 Ω
Digital Inputs	Coaxial, Optical, USB-B
Analog Inputs	2 x Line
Phono Input	Yes
DAC	Yes
Bluetooth	Yes
Dimensions (W x H x D)	430 x 148 x 428 mm