17
English
Operations
(17)
1 Press [MENU].
2 Press [
], [ ] repeatedly to select
“Cartridge Optimiser” and then press
[OK].
3 Press [
], [ ] to select “Measurement
Start” and then press [OK].
• “Prepare Calibration Record” is displayed.
4 Start playback the calibration record
on the connected turntable and then
press [OK].
• Play the outer track first on the calibration
record which has 2 tracks on both sides
(approx. 3 minutes). Play another track if the
optmisation does not start properly.
• The speakers output a test tone.
• Measurement starts for the data of
“Crosstalk Canceller” and “Response
Optimisation”.
5 After displaying “Lift up the tone
arm”, stop the playback of calibration
record and press [OK].
• The measured data processing starts (approx.
10 minutes).
6 After displaying “Completed”, press
[OK].
7 After displaying “Register 1 - 3”, press
[OK] and then [
], [ ] to select the
data to store.
• The optimised data can be stored up to 3
type. The data is overwritten when selecting
the already registered data.
8
(When naming the data)
After displaying “Rename?”, press
[OK].
• When the name is not edited, press [ ] to
exit. The measurement completes and the
optimised data is registered.
9 Press [ ], [ ], [ ], [ ] to enter the
name and then press [OK].
10
After displaying “Registered”, press
[OK] to exit the setting.
• The edited name is stored, the measurement
completes and the optimised data is
registered.
■ “Crosstalk Canceller”/
”Response Optimisation”
Press [MENU].
Press [ ], [ ] to select “Cartridge Optimiser”
and then press [OK].
Press [ ], [ ] to select the registered data
and then press [ ].
Press [ ], [ ] to select “Crosstalk
Canceller”/”Response Optimisation” and then
press [OK].
Press [ ], [ ] to select “On”/“Off” and then
press [OK].
• “Crosstalk Canceller”:
Reduces the crosstalk occurs on the cartridge.
• “Response Optimisation”:
Optimises the resonance occurs on the
cartridge and cable, also adjusts the right and
left balance.
■ Call up the registered setting
Press [MENU].
Press [ ], [ ] to select “Cartridge Optimiser”
and then press [OK].
Press [ ], [ ] to select the registered data
and then press [OK].
■ Edit the name
Press [MENU].
Press [ ], [ ] to select “Cartridge Optimiser”
and then press [OK].
Press [ ], [ ], [ ], [ ] to select the registered
data, then press and hold [OK].
Press [ ], [ ] to enter the name and then
press [OK].
• Only ASCII characters can be used.
• “A” can be added when you press the [
] at
the time of the last letter is selected.
• Press [CLEAR] to delete a letter.
Switching the PHONO equaliser
curve
You can switch the equaliser curve of this unit.
This unit supports the simulated equaliser curve
before unifying to RIAA.
• The factory default is “RIAA”.
1 Press [MENU].
2 Press [
], [ ] repeatedly to select “EQ
CURVE” and then press [OK].
3 Press [
], [ ] to select the equaliser
setting and then press [OK].
• You can also switch the equaliser curve by
pressing [CURVE].
Reducing low frequency noise
Reduces the low frequency noise caused by the
warpage of record. ( 15)
To Next Page
Loading...
Need help?
General
