Technics SX-KN2400

Part V Composer
109
QQTG0692
Composer
KEY IN CHORD MODIFY <PAGE 2/2> (except
for INTRO, ENDING, DRUMS):
Use the GROUP and TYPE
∧
and
∨
buttons
to select the type of pattern progression.
• This setting is for the sound that is going to be
recorded from this time.
5.
Use the buttons below the display to switch to
a different recording part, and proceed to
record each part in turn.
6.
When you have finished recording the rhythm,
turn off the PROGRAM MENUS button.
Chord Modify Change
For data that has already been recorded, you can select the type of pattern progression for the bass and
accomp parts.
• This function cannot be used for the INTRO and ENDING patterns.
1.
On the RECORDING display, press the
CHORD MODIFY CHANGE button.
• The display looks similar to the following.
2.
Use the PART ▲ and ▼ buttons to select the
part you wish to set.
3.
Use the GROUP and MODIFY TYPE
∧
and
∨
buttons to select the corresponding progres-
sion type.
• If a progression type for which the note name
is displayed (in C key) was selected for the
chord group, played notes which are not dis-
played are changed to notes which are dis-
played.
4.
Use the FUNCTION
∧
and
∨
buttons to
enable or disable the function.
KEEP: No change.
CHANGE: The change is enabled.
5.
When you have finished making the settings
for each part, press the OK button.
6.
Press the EXIT button.
10_Part V.fm 109 ページ ２００３年１月２７日 月曜日 午後１時４５分