Technics SX-P50

Reverb depth
The type and depth of the DIGITAL REVERB can be adjusted for each sound.
1.Select a sound. 4.Use the VALUE (TRANSPOSE) buttons to adjust the
depth of the reverb.
2.Select a type of DIGITAL REVERB. وو پک󰾯
DOWN UP
DIGITAL
(t C) EA
E
ЖАГЫ C) VALUE
CONCERTO
• The current reverb depth (1—10) is shown on the dis-
3. While pressing the MODE SET button, press the DIG- play.
ITAL REVERB button. e Each press of the UP button increases the reverb
depth, and each press of the DOWN button decreases
EE — the reverb depth.
SET pene « To return instantaneously to the standard reverb
оне, depth, press the two VALUE buttons at the same time.
о
HALLÓ
CONCERTO 5.When you have finished adjusting the reverb depth,
press either the MODE SET button or the DIGITAL
REVERB button.
• The indicator for the selected type flashes. e The selected type and depth are memorized for each
e If the DIGITAL REVERB was off, ROOM is selected. sound and are recalled whenever the same sound is
selected again.
String resonance
String resonance is the sound heard in an acoustic piano when the struck strings produce a sympathetic resonance
of the other unstruck strings. For the CONCERT GRAND, UPRIGHT and POP GRAND sounds, string resonance is
produced as long as the sustain pedal (foot switch) is depressed. The amount of string resonance can be adjusted,
and is common for all the sounds.
* When the DIGITAL REVERB is on, there is no string resonance.
1.Press and hold the CONCERT GRAND button for 3.When you have finished adjusting the string reso-
about 3 seconds. nance, press the CONCERT GRAND button again.
965565005606
« The indicator flashes.
2.Use the VALUE (TRANSPOSE) buttons to adjust the
amount of resonance (0-10).
TRANSPOSE
чв p OO
VALUE
• Each time the UP button is pressed, the resonance
increases. Each time the DOWN button is pressed,
the resonance decreases.
* When set to 0, there is no string resonance.
• Pressing both buttons at the same time will return the
instrument to the standard resonance.
12
QQTGO606