Technics SX-P50

Assigning the MIDI GHANNEL (MIDI GH)
You can assign a MIDI CHANNEL number (1-16) to this
instrument,
Normally, data can be exchanged only when the chan-󰾰 ه
nel on the transmitting side matches the channel on󰾰
the receiving side.󰾰
• The default channel setting is 1.
=While pressing the MODE SET button, use the 16 • The selected MIDI CHANNEL number is shown on the
lowermost keys (see illustration) to assign the desired display.
MIDI CHANNEL number.
à inn |
The following MIDI functions can be set.
The DIGITAL EFFECT button and some of the SOUND
buttons, when used in conjunction with the MODE SET
button, serve to set the following MIDI functions.
| Function | on (when indicator is lit) off (when indicator is not lit)
The piano can be used as a multiple sound This piano cannot be used as a multiple
generator, and data can be received on each MIDI sound generator. Data can be received
channel. only on the set MIDI basic channel. In
this case, the produced sound
corresponds to the selected sound as
indicated on the panel (defauit status).
ein the initialized state, the MIDI channel and sound assignment that can be used on this
MULTI instrument is as shown below (the ORGAN PRESETS becomes the sound that is selected
TIMBRE at that time).
SOUND
CONCERT
GRAND GRAND UPRIGHT E PIANO EPIANO2 1 VIBES STRINGS EEA
С) @ © © © © © © @ ®
PIANO ————
• When the power is turned оп or when this instrument is initialized, the sounds for each
channel that were changed by receiving PROGRAM CHANGE numbers return to the
sounds indicated on the panel.
Data is received for all MIDI channels. Data is received only on MIDI channels
which are matched (default status).
» For assigning this instrument's MIDI
channels, refer to the section
"Assigning the MIDI CHANNEL (MIDI
CH)" above.
PROGRAM CHANGE data is transmitted/received PROGRAM CHANGE data is not
(default status). transmitted/received.
PROGRAM | *You can also transmit data for any PROGRAM
CHANGE CHANGE number. (Refer to page 15.)
e Please refer to page 16 for information about
the program change number of each sound
button.
PEDAL Pedal operation data is transmitted/ received Pedal operation data is not transmitted/
(default status). received.
EFFECT The DIGITAL EFFECT on/off 65 The DIGITAL EFFECT on/off status is
transmitted/received (default status). not transmitted/received.
14
QQTG0606