Technics SX-P50

You can also use the sound buttons to specify the
PROGRAM CHANGE number.
The ORGAN PRESETS are assigned numbers 9 to 17
іп the CLASSICAL, JAZZ numerical order and change
depending on the sound selected at that time.
SOUND
Se
GRAND GRAND UPRIGHT EPIANO1 EPIANO2 3 VIBES STRINGS VOCAL PRESETS
QIOIgIOQIOIOQQION
PIANO ———————
Symptoms which appear to be signs of trouble
Phenomenon
No sound is produced when the | ePlease connect a speaker system or headphones to hear the
keyboard is played. sound.
Bi Backup memory
This instrument’s various settings are always maintained
as long as the AC adaptor is connected. When the AC
adaptor is removed, the settings are remainned for about
10 minutes, after which they return to the factory-preset
status.
16
QQTGO606
° No sound is produced if the MAIN VOLUME is set to MIN.
Use the sliding control to set the volume to an appropriate level.
elf the MIDI LOCAL CONTROL is set to off, set it to on, or turn
the power ON after turning it OFF once. (Refer to page 15.)
Nothing is shown on the display. e The setting values, etc. are indicated on the display. During
normal performance, however, the display is off.
Data cannot be exchanged through | eMatch the channels on the transmitting side and the receiving
MIDI terminals. side. (Refer to page 14.)
Remedy
® Initialized settings
To return this instrument's settings to the factory preset
status, with the power ON, while pressing the MODE SET
button, press the keyboard key indicated in the illustration
below. Or, with the power OFF, while pressing the key-
board key indicated in the illustration below, turn the
power ON.
¥