Technics SX-PR100 - Page 19

IwH—--OzmM
> Setting Other Modes
(PR100/PR200) (PR300)
JAZZ STRING PIPE JAZZ — STRING
ORGAN ensemBLe BRASS ORGAN ORGAN ENSEMBLE
1°) (eo) ° oO fe) °
MIN PIANO MEDLEY MIN PIANO MEDLEY
RANGE TUNING RANGE TUNING
Using the three LEFT TONE buttons and the BALANCE
buttons, the following functions can be set.
1. Press the RECORD button. The indicator flashes.
2. Press the MODE SET (FILL IN & INTRO) button. The
indicator flashes slowly.
3. Set each mode.
@ MIN RANGE
Pressing this button on broadens the range at low volumes. If
a key is pressed very slowly, it may not produce any sound.
@ PIANO TUNING
When this button is on, the sound is alittle lower for !ow notes
and alittle higher for high notes as on a regular piano. When it
is off, the tuning is even.
FILL IN & INTRO RECORD
fo) °
@ MEDLEY
When this button is on, the contents of the optional memory
card are performed repeatedly.
With this button on when playing back a NORMAL 1 mode disk
on an optional Digital Disk Recorder, ten consecutive songs
will be played in order, starting with the song selected.
@ BALANCE
Choose from among 4 preset volume levels and set the
maximum volume level for each part using the & and ¥
BALANCE buttons.
4. Once the required modes have been set, press the
RECORD button again to turn it off.
© Modes set using these procedures will not be recorded in
the PLAY SEQUENCER or the FULLBAND SETTING COM-
PUTER. MEDLEY will be cancelled when the power is
turned off.
Symptoms which appear to be signs
of trouble
The
following
changes
in
performance
may
occur
in
the
Technics
digital
piano
but
do
not
indicate
trouble:
Phenomenon
Remedy
The buttons, keys, etc. malfunction.
°Press the FSC (FULLBAND SETTING COMPUTER) button to turn it on, and
then press the INITIAL key on the keyboard.
elf
the
buttons
and
keys
do
not
return
to
normal,
turn
off
the
POWER
once,
then
on
again.
Turn
on
the
FSC
button
and
press
the
INITIAL
key.
No sound is produced when the keys are
pressed.
No sound is produced when the LEFT and RIGHT indicators in the BALANCE
section are off. Press the A buttons.
The keys on the left keyboard do not
sound.
When no TONE indicator is lit for the left section, the left keyboard keys do
not sound. Select and press a TONE button for the left keyboard.
The normal sound is not produced when
the keys are played. Instead, the sounds
from rhythm instruments are heard.
TONE block.
When the KEYBOARD PERCUSSION button in the RIGHT TONE block is on, the
sounds of the percussive instruments indicated above the keys are produced.
To return to the normal piano sound, select a different tone in the RIGHT