Part XI MIDI
132
QQTG0701
MIDI
Computer Connection
These settings are used to select the mode related to MIDI signal flow when a personal computer is con-
nected to the USB terminal of this instrument.
• When connecting to a personal computer, install the USB driver on the included CD-ROM to the computer first. (Refer to the
separate manual for more information.)
1.
Turn off the power to this instrument.
2.
Connect a personal computer to the USB ter-
minal on the rear of this instrument.
3.
Turn on the power to this instrument.
4.
On the MIDI MENU display, select COM-
PUTER CONNECTION.
• The display looks similar to the following.
5.
Use the
∧
and
∨
buttons to select a mode.
NORMAL:
Ordinary mode
PC as master:
The mode which is appropriate for data trans-
mission
PR as master:
The mode when this instrument is used as the
master keyboard.
PR as slave:
The mode when this instrument is used as a
slave instrument.
INTERFACE:
The mode when this instrument is used as a
connecting device between a PC with only
USB terminals and an instrument with only
MIDI terminals.
16_Part XI.fm 132 ページ ２００３年５月１６日 金曜日 午後１１時４０分
To Next Page
Loading...
