Technics SX-PX228B User Manual

Volume balance
1.Press the two SOUND buttons continuously
for 2 or 3 seconds.
e The indicators for the two sounds flash, and
the current volume balance is shown on the
display.
2. Use the TEMPO buttons to adjust the volume
balance.
Left Sound
e Each time the A button is pressed, the volume
of the right-side sound increases, and each
time the V button is pressed, the volume of
the left-side sound increases. Play the key-
board to hear the volume balance.
e |f the two TEMPO buttons are pressed at the
same time, the volume is equally balanced.
e On the display, the right-side sound is louder
when a number 1 to 10 is shown, and the
left-side sound is louder when a number -1 to
—10 is shown.
3. When you have finished adjusting the volume
balance, press any SOUND button.
The keyboard can be divided into right and left sections (split) so that, for example, you can play bass
sounds in with your left hand and piano sounds with your right hand.
1. Use the SOUND buttons to select the sounds
for the right part.
e Two sounds can be mixed.
2.Use the LEFT SOUND buttons to select a
sound for the left part.
LEFT SOUND
ACOUSTIC ACOUSTIC CLECTRC OTHER
BASS «AACE BASS SOS m
o
e Although octave and volume settings may dif-
fer depending on the sound, these can be set
as desired. (Refer to page 17.)
SPLIT POINT
You can specify a different split point.
1. While pressing the MODE SET button, press
the SPLIT POINT (ACOUSTIC BASS) button.
MODE
SET коли
o
e The indicator flashes.
e SPL is shown on the display.
B OTHER SOUNDS
You can also select a sound for the left part from
the SOUND buttons. While pressing the OTHER
SOUNDS button select a sound from the SOUND
buttons.
e The initial setting is STRINGS.
e When you select ORGAN PRESETS, while
pressing the OTHER SOUNDS button, use the
TEMPO buttons to select an organ sound.
(The organ sound selected for the right part
will not change, so you can choose different
organ sounds for the right and left parts.)
3. Different sounds are now produced on the right
and left sections of the keyboard.
e The split point is initially set at G2 (the G to
the left of middle C).
4. To cancel the keyboard split, turn off the sound
you selected in step 2.
e When the power is turned on, the keyboard is
not split.
2. Specify the desired split point by pressing the
corresponding key on the keyboard.
e The split point is set at the location of the
pressed key (the lowest note of the right key-
board section).
e Press any key on the keyboard to exit the
setting mode.

Technics SX-PX228B Specifications

General

Brand	Technics
Model	SX-PX228B
Category	Amplifier
Language	English