2RSS-5
CFE641-5
CFE942-5
26
Caution!
• The hob must be installed by a suitably qualified person. Please never conduct the
operation by yourself.
• The hob shall not be mounted to cooling equipment, dishwashers and rotary dryers.
• The hob shall be installed in a way that ensures correct ventilation and clearances.
• Any surrounding surfaces will meet requirements in regards to temperature
resistance.
• A steam cleaner is not to be used.
Electrical Connection
Connecting the cooktop to the mains power supply
If connecting the cable directly to the mains, install a suitable isolating switch with a
minimum contact opening of 3mm between the appliance and the mains. The
isolating switch should be sized according to the load on the appliance rating label
and should comply with current regulations (the earth wire should not be interrupted
by the circuit breaker)
Connection to the electricity supply must be made by an authorized person in
accordance with the wiring rules AS/NZS3000. Ensure the supply cable cannot
contact any hot surfaces.
Immediately after installation, carry out a thorough inspection and test of the
appliance. If the appliance fails to operate correctly, after checking that you have
followed the user instructions correctly, disconnect the appliance and contact the
27
2RSS-5
Glen Dimple Service department. Never attempt to repair the appliance.
x
To Next Page
Loading...
Need help?
General
