7
Audio Mode (Stereo/Mono)
Denotes if the broadcast is in Stereo or Mono.
To specify that a station can be only played in mono or that
stereo is allowed:
1. Press and hold the INFO/MENU button for 3 seconds.
2. When the <Scan setting> option appears press either
or
and
nd <Audio S
et
ti
ng>
, pres
s the
ENTER button.
3. Use the
or buttons to cycle through the 2 options
<Forced Mono> or <Stereo Allowed>. Press ENTER to
select.
Stereo allowed: Means any station broadcast in stereo
with a strong enough signal will be played in stereo.
Mono only: Plays ALL stations in mono regardless of the
availability of a stereo signal.
Time
Displays the current time. Please see Page 7 for setting.
Date
Displays the current date. Please see Page 7 for setting.
Radio Text
Displays scrolling text broadcast by the station ( only if
broadcast ).
Scan Modes
Auto Scan
The Auto scan setting will scan up or down depending on
where the starting frequency is. Once it nds a station it
will stop.
There are 2 options to use when using this function.
NOTE: Ensure you are in the FM mode before following the
below steps.
1. Press and hold the INFO/MENU button for 3 seconds.
2. When the <Scan setting> option appears press the
ENTER button.
3. You will have the choice of either <Strong Stations
Only> or <All Stations> using the
or buttons.
Strong stations only, will only stop at stations with a
strong signal. All stations will stop at any station found
with a strong or weak signal.
4. Make your choice by pressing the ENTER button to
activate the setting.
Now when you press and hold the BACK/SCAN button the
auto scan searches depending on what setting you chose.
The time & date can be set automatically from the DAB
broadcast or set manually.
1. Press and hold the INFO/MENU button for 3 seconds.
2. When the <Scan setting> option appears press either
or and nd <System>.
3. Press the ENTER button, use the
/ buttons to nd
<Time> and press ENTER.
Inside the <Time> menu there are several options. <Set
1
2/24 Hour>
, <S
et Ti
me/
Date> & <Auto Upd
ate>
<Set 12/24 Hour> Use the
/ buttons to select 12 or
24 hour and then press the ENTER button to activate.
<Set Time/Date> When activated the Hour digit ashes,
use the
/ buttons to set the digit to the correct hour
then press ENTER, repeat for the minutes again pressing
ENTER when set.
The process for setting the date is exactly the same as the
above. Press ENTER to nalise the setting once complete.
<Auto Update> Use the
/ buttons to cycle through
the various options for auto setting the time & date. These
range from. <Update from any>, < Update from DAB>, <
Update from FM> and <No Update>.
NOTE: When the power is switched OFF ( not standby ) the
settings will be lost.
FM OPERATION TIME AND DATE FUNCTIONSFM OPERATION
To Next Page
Loading...
Need help?
General
